Electric Actuators

The LEF series slider type electric actuator features a low profile height of 46mm (LEF16). The actu..

The LEPY is a rod type electric actuator with a miniature form factor, small enough to fit in the pa..

The X8 option is a dust-proof and water-jet-proof specification equivalent to IP67. This spec is ac..

The LECPA is a driver for LE’s 24VDC step motors. This driver controls motion by interpreting a puls..

The LEYG guided rod electric actuator pairs a LEY actuator with a bolt-on bearing block with double ..

The LECP1 is a programless controller for LE’s 24VDC step motors. 14 positions with speed and accele..

The LECP1 is a programless controller for LE’s 24VDC step motors. 14 positions with speed and accele..

The JXC51 and JXC61 are controllers for LE's 24VDC step motors. Enter up to 64 motion control ..

The LEM electric actuator family features the lowest table height of all sliders, 40mm or less. Four..

The LECSS drivers are compatible with the Mitsubishi's servo system controller network, or SSCN..

LEC-G is a Fieldbus-compatible Gateway (GW) unit for electric actuators. Protocols include CC-Link ..

The LES electric actuator combines a motor and ball screw drive, worktable, and linear guide in comp..

The LECPA is a driver for LE’s 24VDC step motors. This driver controls motion by interpreting a puls..

The LAT3 Card Motor deviates from LE actuators by implementing a unique magnetic linear motor. The u..

The LATCA controller is the second controller available for the LAT3 magnetically driven slide table..

The LEPY is a rod type electric actuator with a miniature form factor, small enough to fit in the pa..

An LEFG guide shares dimensions with the LEFS and LEFB body, but has no motor. It functions as a sup..

The JXC51 and JXC61 are controllers for LE's 24VDC step motors with the batteryless absolute en..

The rodless LEFB slider is an electric actuator with a load mounting platform situated above a belt ..

The LECSC drivers are compatible with the CC-Link v1.10 open industrial network, operating AC servo ..

The LECPA is a driver for LE’s 24VDC step motors. This driver controls motion by interpreting a puls..

The LEYG actuator is a rod type ball screw actuator paired with a bolt-on bearing block with double ..

The LEFS is available in a motorless type, permitting the mounting of an AC servo motor other than t..

The LEHF gripper uses a belt driven slide shaft to open and close the fingers. The low profile, fla..

The rodless LEFS slider is an electric actuator with a load mounting platform situated above a ball ..